White Reinforced Accessories 2018-12-06T19:58:40+00:00

White Reinforced Accessories

RoofKit offers a complete line of high-quality accessories for the installation of your White Reinforced roof.

View details and additional information below on each of our accessory products.

White Reinforced Roofing Membrane

Commercial-grade 45 mil; resists moisture, ozone, and ultraviolet radiation.

Sizes:

  • 6’6” x 20 ft rolls (1 or 2 per tube)
  • 10 ft x 20 ft rolls
  • 10 ft x 100 ft rolls

Caution:

The White Membrane is slippery, especially when wet, dusty or covered with snow, frost or ice.

See additional cautions and warnings on page 3 & 4 of the White Membrane Pocket Application Guide.

Important Notice About Water Vapor or Condensation:
Control of water vapor and subsequent condensation is the responsibility of the person designing the roofing assembly. Exposure of the roof to temperatures below the dew point temperature of the air inside the building will cause condensation to form within the roofing assembly. Condensation forming within the roofing assembly and dripping into the building is not a roof leak. The person designing the roofing assembly and the person installing the roofing assembly must use proper water vapor control measures when designing and installing the roofing assembly to prevent condensation from forming within the roofing assembly.

White Membrane Water Based Bonding Adhesive

Adheres white membrane to suitable substrate. High coverage rate, environmentally safe.

Sizes:

  • 3.5-gallon pails or 1-gallon pails, 4 per case

White Membrane Seam Tape

Seams two white membrane sheets together. Heavy duty, easy to use, with no caulking required.

Sizes:

  • 3” x 50’ rolls, 1 roll per box

White Membrane Cover Strip

Peel and stick tape for completing metal edge detail. Also for patching long tears in membrane.

Sizes:

  • 6” x 50’ rolls, 1 roll per box

White Membrane Seam Kit

For seaming up to 25 feet of membrane.

Sizes:

  • 25 ft. roll of 3” Seam Tape, 1 pint Primer, scrubbie pad, seam roller, and 2 wipe cloths

Patch & Corner Cover Kit

Used for repairing small cuts and holes in white membrane.

Sizes:

  • (6) 8” circular peel and stick patches, 1-pint seam primer, scrubbie pad, wood roller and wiping cloths.

White Skylight Flashing

Used for detail work at roof skylights.

Sizes:

  • 8” x 14’ rolls, 1 roll per box

White P/S Pipe Boot

Seals pipes, stacks or vents up to 6” in diameter.

Sizes:

  • 1 boot, 1 clamp per box

White Termination Bar

For perimeter and edge terminations.

Sizes:

  • 10 ft. lengths, 25 lengths per tube
  • Aluminum also available

White Caulk

For sealing seams and terminations.

Sizes:

  • (12) 10.3 oz. tubes per case

RoofKit White Walk Pad

Used to protect membrane in heavy foot traffic or maintenance areas. Non-skid surface.

Sizes:

  • 36” x 36” each

Compatible “Blue Label” RoofKit Products:

Seam Primer

Used for cleaning and priming all roof membrane surfaces prior to installation of RoofKit products including Tapes, Multi-Purpose Adhesive, Caulk, Corner Covers and Pipe Boot

Features:

  • One step product for cleaning and priming roof membrane
  • Required for use with all tape products
  • Fast drying for quick installation of adhesives or tapes
  • Promotes uniform adhesion of tape products

Sizes:

PRODUCT SIZE
U/M WEIGHT
UNIT OF MEASURE
PACKAGING
1 GALLON CANS
32LBS
CASE
4/1 GALLON CANS PER CASE
1-PT CAN INCLUDED IN
SEAM KIT AND PATCH KIT
N/A
N/A
INDIVIDUAL PT. CANS IN SEAM
KIT AND PATCH KIT

Caution:

RoofKit Seam Primer REQUIRES the use of solvent-resistant gloves when using this product. These materials contain petroleum distillates and are extremely flammable. Care MUST be taken to avoid open flames. Do not smoke when using these products. Properly dispose of used rags and scrubbie pads once they have dried out. Store in dry location away from heat and sunlight. READ ALL CAUTIONS AND WARNINGS IN THE POCKET APPLICATION GUIDE PAGES 2-3.

Screws and Plates

Used for the secure installation of any approved insulation board or the installation of the Reinforced Strip. Screws can also be used for Termination Bar installation

Features:

  • Convenient packaging of screws and plates in one box
  • Heavy duty professional strength products

Sizes:

PRODUCT SIZE
U/M WEIGHT
UNIT OF MEASURE
PACKAGING
100 – 3” SCREWS
100 – 3” PLATES
30 LBS/CS
BOX/100
5 BOXES TO A CASE

Caution:

Sharp edges on plates and sharp points at end of screws. READ ALL CAUTIONS AND WARNINGS IN THE POCKET APPLICATION GUIDE.

Waterstop

Used to prevent water infiltration UNDER the membrane at terminations, pipe boots, and drains. Acts as extra protection for your roof.

Features:

  • A gray siliconized gasket caulk that is very sticky – use caution when opening tubes and during application
  • Does 20 Lineal feet per tube

Sizes:

PRODUCT SIZE
U/M WEIGHT
UNIT OF MEASURE
PACKAGING
11 OZ TUBES
11 LBS
CASE
10 TUBES / CASE

Caution:

These materials contain petroleum distillates and are extremely flammable. Care MUST be taken to avoid open flames. Do not smoke when using these products. Safety Data Sheets (SDS) are available for these products and should be consulted. Store in dry location away from heat and sunlight. READ ALL CAUTIONS AND WARNINGS IN THE POCKET APPLICATION GUIDE PAGES 2-3

5′ & 10′ Aluminum Termination Bar

Used for horizontal or vertical termination of the membrane at walls and gutters or over the edge of the roof surface

Features:

  • Aluminum extruded bar with pre-drilled holes for easy installation
  • Aluminum will not rust or corrode
  • Each pre-drilled hole must be filled with the proper length screw
  • RoofKit Waterstop is usually installed under the White Reinforced membrane just behind the Termination bar to prevent any water infiltration
  • Caulking channel already provided for easy caulk installation

Sizes:

PRODUCT SIZE
U/M WEIGHT
UNIT OF MEASURE
PACKAGING
5’ LENGTH
23 LBS
TUBE
5’ BAR 25/TUBE
10’ LENGTH
51 LBS
TUBE
10’ BAR 50/TUBE

Caution:

Sharp edges at the ends of the bar. READ ALL CAUTIONS AND WARNINGS IN THE POCKET APPLICATION GUIDE PAGES 2-3.